Dosflash manual

 · DosFlash supports two flashing modes, Auto and Manual. If you type DOSFLASH at a DOS prompt it will start in Auto mode. All drives and the corresponding flash chips are detected automatically. If you can't get a flash chip recognized due to a bad flash or other problems you should use the Manual www.doorway.rure Version:  · Press the relative number of your detected device under DOSFLASH (1 in my case). Type "E" (without quotes) to fully erase your drive eeprom and wait for the end of the task. Now type again DOSFLASH, press the relative number and the "W" letter (without quotes) for writing firmware.  · From www.doorway.ru ===== www.doorway.ru version ===== The DOS Flash utility is designed to update the computer system firmware (BIOS) from a DOS, FreeDOS, or similar environment. Windows command line is not supported. The DOS Flash utility consists of the executable file (www.doorway.ru) and a driver file (www.doorway.ru) specific to updating the system BIOS.

The DOSFLASH command to write to a lite-on is DOSFLASH (in MANUAL mode) If you want to try and flash it like a BENQ then try this. Dosflash w PORT 1 A0 2 1 4 lite_www.doorway.ru 0. And all that took was a simple google search of YOUR THREAD TOPIC. Fu**ing Genius. Then boot in to your dosflash bottable and dump the firmware. Use the transfer tool to your correct firmware and flash it. NS40 Recovery Image: Flashed an NS50 firmware to an NS40 drive and can no longer read disks this IMG has all the NS40 FW you need to recover your drive just follow my dos flash video guide linked above. Attention: Do not turn off or suspend the computer until the BIOS update has been completed. 3a) BIOS Update - DOS Run \DOS\www.doorway.ru to update your System BIOS in DOS environment. 3b) BIOS Update - Windows: Open a command prompt (www.doorway.ru) with administrator privileges.

DosFlash16 Manual Mode Examples for LiteOn Slim Extract drive key on a "PLDS DGD4S " DOSFLASH LITEON K V3 A0 - Unlock SPI Flash on a "PLDS DGD4S " DOSFLASH U 1 A0 3 0 - Read firmware on a "PLDS DGD4S " DOSFLASH R 1 A0 3 0 4 www.doorway.ru 0 - Write firmware on a "PLDS DGD4S ". From www.doorway.ru ===== www.doorway.ru version ===== The DOS Flash utility is designed to update the computer system firmware (BIOS) from a DOS, FreeDOS, or similar environment. Windows command line is not supported. The DOS Flash utility consists of the executable file (www.doorway.ru) and a driver file (www.doorway.ru) specific to updating the system BIOS. DosFlash supports two flashing modes, Auto and Manual. If you type DOSFLASH at a DOS prompt it will start in Auto mode. All drives and the corresponding flash chips are detected automatically. If you can't get a flash chip recognized due to a bad flash or other problems you should use the Manual mode.